This is a large mold, over 5'x5' in size, and too large to ship regular UPS or FedEx, so must ship freight. As such, it is not eligible for FREE SHIPPING, and so please order this mold separately from any other items, and we will contact you with a freight shipping price based on your address (or feel free to email us at email@example.com before placing the order, for a shipping quote). Average freight cost for this size of mold is around $150-$250.Product Specifications:
- Our SDP (Super Durable Polyurethane) Line of Sink Molds are made from the highest grade Polyurethane Rubber. A lifetime of reusability.
- The Bent Coffee Table Mold is 5' x 5' in size, and specially made to allow 'bending' the mold as the concrete sets up, curving the concrete to the shape of the 4 legs.
- SDP-60 Measurements (of finished concrete piece):
- Length: 60"
- Width: 60"
- Depth: 3/4"
- This Bent Table mold can be used flat to create a concrete slab, nice and flat... or it can be 'lifted' up in each corner, when the concrete placed in it has set up just enough to not slump. Each corner of this mold has a 45 degree flat section 2" long, which when the table corners are bent up, will create a flat 2" wide 'foot' that will rest flatly on the ground as the base of each leg.
- Vessel Molds like this can easily turn leftover concrete into high revenue earnings.
- All our molds have Lifetime Guarantee against defect. This Guarantee does not cover misuse of the Molds (Dropping the Mold, Prying the Mold out using a screwdriver, Driving onto it with a truck tire... etc.).
- Expressions LTD will not be held liable for any damage, misuse, or collateral damages resulting from use of any of our products. If there is a flaw or defect with a product, we will fix or replace the product.
- Watch videos and tutorials on our YouTube Video Page.
- Wax the mold, appling 3-5 coats of Mold Release Wax to the mold, lightly buffing between coats once it hazes.
- Apply a thin coat of Rubber Safe Form Release to the Mold just prior to casting the concrete piece.
- Various methods can be used to cast the concrete piece. If attempting to bend the concrete for the legs, it is strongly recommended that you use a very high strength, specialty concrete mix that is suited for this, such as the Surecrete XS-Precast Mix (sold here)
- View our Concrete Recipe section for tips on making your own concrete mixes.
- GFRC: Cement and fiberglass is sprayed on and hand packed into the form and around the sink.
- Wetcast: Oatmeal consistency concrete is placed in form and vibrated.
- Any voids in the finished concrete can be filled using a Cement Slurry.
- If the steps above were followed for the Mold Setup, then most Molds will usually pull out of the concrete with little effort.
- If the mold is difficult to remove, try:
- Compressed air shot around the Mold rim will break the suction holding the Mold in the concrete.
Mold Clean-up and Care:
- Clean Mold with a sponge after each use. Any dried cement residue can be removed with a scotch-brite pad (as outlined above in the Mold Setup section. A light muriatic acid wash (20:1, 20 parts water to 1 part muriatic acid) can also remove cement scale.
- Waxing and buffing the Mold after cleaning it use is recommended to protect the Mold until its next use.