- Flanders Weave stencil.
- Stencils are designed for use with wet concrete and Overlay Resurfacing Systems.
- Manufactured in the USA, using superior high-strength white paper that can handle the toughest conditions.
- White Paper Stencils are superior to most other 'brown' stencils, that are thinner, have problems laying flat, and tear easily when used.
- Stencils are used to achieve the look of stone, tile or brick without the higher installation and maintenance costs associated with such applications.
- Stenciled concrete and overlays leave a flat and even surface better suited for pool decks, walkways, driveways and interior floors.
- Non-adhesive white paper stencils which are poly-coated on both sides for maximum moisture resistance. Made of thicker paper, these stencils may be used more than once depending on application method.
- Flanders Weave Coverage:
- Roll is 33" Wide, and sold in 250 sq. ft., 500 sq. ft. and 1000 sq. ft. sizes.
- Plan on 10% waste with 2-way line pattern stencils, and 20% waste with random stone patterns.
- Largest Stone Size: 4 7/8" x 10 1/2"
- Joint Width: 1/2"
- *NOTE: Pattern measurements may vary slightly due to normal manufacturing tolerances.
- Standard Application Method- Fresh Concrete:
- Apply stencil to fresh concrete. Lightly press stencil evenly into concrete surface. Apply Color Hardener and/or Antiquing Release Agent followed by Texture Stamp Mats or Texture Rollers. Remove stencil when concrete is hard enough to walk on, and cement paste is set up enough to flake off the stencil.
- Standard Application Method- Overlay
- Lay the stencil down on the existing concrete surface. Once stencils are evenly laid out and flat, spray an Acrylic Overlay as straight down as possible, not at an angle, over the stencil. Remove stencil carefully. Experienced users can re-use sections of the stencils (watch video below for example).
- Alternate Application Methods:
- Vertical concrete surfaces/walls.
- Trowel over stencils with a thin layer of Micro-Topping.
- Careful use of Acid Stain is also possible over a stencil, but recommended for experienced applicators only.
- Can also be used with Drywall & pigmented drywall mud, paint, as well as with Asphalt spray coatings.
- Professional tips for stencil use:
- When using stencils in new concrete: Slump should be 4-5", to reduce excess bleed water. Use water reducer (SP-7000 Water Reducer sold here). Use surface retarder for hot or windy weather.
Video: Stencils with New Concrete (Color Hardener, Release, & Stamping)
Video: Stencils with sprayed Acrylic Overlay